Page 1
380mm x 240mm x 460mm / 15in x 9.5in x 18.2in(AK-250) Dimension 333mm x 200mm x 330mm / 13.2in x 7.9in x13in (AK-150) Weight 25 kg / 55 lbs (AK-250) / 9.6 kg / 21.3 lbs(AK-150) AKI COLOR User Guide Please read these instructions carefully before use WWW.JBSYSTEMS.BE...
4. How To Set The Unit 4.1 Control Panel 4.2 Main Function 5. How To Control The Unit 5.1 By master/slave preprogrammed function 5.2 By Akicolor Processor (AK-1) controller 5.3 By universal DMX Controller 5.4 DMX512 Configuration 5.5 DMX512 Connection 6. Troubleshooting 7. Fixture Cleaning...
7. Fixture Cleaning 1. Safety Instruction The cleaning of internal and external optical lenses and/or mirrors must be carried out Please read carefully the instruction, which includes important periodically to optimize light output. Cleaning frequency depends on the environment in which information about the installation, usage and maintenance.
2. Technical Specification 6. Troubleshooting Power supply Following are a few common problems that may occur during operation. Here are - AC 120V ~ 60Hz / 230v ~ 50Hz some suggestions for easy troubleshooting: Lamp A. The unit does not work, no light - MSD 250W (AK-250) / CDM-T150W (AK-150) 1.
3. Connect the unit together in a “daisy chain“ by XLR plug from the output of the unit to the input of the next unit. The cable can not be branched or split to a “Y“ cable. DMX512 is a very high-speed signal.
Pattern 0 Color chasing – 8 after 8 in sequence 5. If you have another unit, to link the unit together, please refer to chapter 5.3 DMX512 Connection . 5.3 By universal DMX Controller If you use a universal DMX controller to control the units, you have to set DMX address from 1 to 512 channel so that the units can receive DMX signal.
To confirm the selected functions 3. DMX input/output For DMX512 link, use 3-pin XLR plug cable to link the unit together. 4.2 Main Function To select any of the given functions, press the MENU button up to when the required one is showing on the display.
Pressing ENTER button and the display will light on. Use “-“ and “+“ button to change the DMX512 address. button, the unit will focus on different color each time you press ENTER button. To go back to Once the address has been selected, press the ENTER button to setup the DMX address.