Warnings; Choice Of Electrical Connection - AEG COMPETENCE D2160-1 Operating Instructions Manual

WARNINGS:

·
This appliance must be installed by a
qualified electrician/competent
Safety may be impaired if installation is not
carried out in accordance with these
instructions.
·
This appliance must be earthed.
·
Do not remove the screws from the earth
tab extending
terminal block (Fig. 1).
·
Before connecting the appliance make
sure that the voltage of your electricity
supply is the same as that indicated on the
rating plate. This is situated on the lower
front frame of the appliance and can be
seen upon opening the door. Alternatively
the rating plate may also be found on the
back or top of some models (where
applicable).
·
Do not alter the electrical circuitry of this
appliance.
CHIOCE OF ELECTRICAL CONNECTION
·
There are three possible ways to connect your
appliance. In each case the appliance should be
operated using at least 6mm
PVC insulated multicore cable. Please choose from
the most appropriate after reading the different
methods:-
a) By connecting the appliance to a cooker point
(having a double pole isolating switch with at least
3mm contact separation in all poles and neutral) and
protected with a fuse or miniature circuit breaker at
your mains fuse box.
Subject to Regional Electricity Company
regulations if you wish to connect the
oven and hob to the power supply you
may use one of the following two:-
methods.
b) By connecting the appliance together with a hob
directly to a cooker point(s). Having a double pole
isolating switch with at least 3mm contact separation
in all poles and neutral.
c) If you wish to connect an oven and a hob to a
cooker point you can, by connecting the oven and
hob separately to the cooker point. Oven and hob
units should be separately connected to a cooker
point. See Fig. 2.
person.
from the oven mains
2
twin core and earth
Fig. 2
32
Fig. 1