Operation - Electrolux 61402 G Instruction Booklet

6

Operation

Hob burners control knobs
The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the burners
For easier lighting, proceed before putting a pan on the pan support.
To light a burner:
turn the relevant knob anticlockwise to maximum position (
Upon ignition, keep the knob pushed down about 5 seconds. This will allow the
"thermocouple" (Fig. 1 - letter D) to be heated and the safety device to be
switched off, otherwise the gas supply would be interrupted.
Then adjust the flame as required.
If the burner does not ignite, turn the control
knob to zero, and try again.
If you cannot light the flame even after several
attempts, check the "cap" (Fig. 1 - letter A) and
"crown" (Fig. 1 - letter B) are in the correct position.
When switching on the mains, after installation
or a power cut, it is quite normal for the spark
generator to be activated automatically.
In the absence of electricity, ignition can occur
without the electrical device; in this case,
approach the burner with a flame, push the
relevant knob down and turn it anti-clockwise
until it reaches the "maximum" position.
If the control knobs become difficult to turn,
please contact your local Service Force Centre.
).
A - Burner cap
B - Burner crown
C - Ignition electrode
D - Thermocouple
Fig. 1