What To Do If - AEG 66201 KF-N Installation And Operating Instructions Manual

What to do if ...

The cooking zones will not
switch on or are not func-
tioning
Acoustic signal sounds
when appliance is switched
off
The residual heat indicator
is not displaying anything
The automatic warm up
function is not switching
itself on
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5
seconds another acoustic
signal sounds
_ is lit
20
Problem
More than 10 seconds have
passed since the appliance
was switched on
The child safety device is
switched on
Several sensor fields were
touched at the same time
Safety cut-out has been
triggered
STOP+GO is activated u
The control panel is wholly
or partly covered by ob-
jects.
The cooking zone was only
on for a short time and is
therefore not hot
There is still residual heat
on the cooking zone h
The highest heat setting is
set Ç
The heat setting was set
using the sensor field
The On/Off sensor field has
been covered up, e.g. by a
cloth
Overheating protection for
the cooking zone has been
triggered
Possible cause
l
Remedy
Switch the appliance on
again.
Deactivate the child safety
device (See the section
"Child safety device")
Only touch one sensor field
Remove any objects that
are lying on the control
panel. Switch the appliance
on again
Switching off STOP+GO
Remove objects.
If the cooking zone is sup-
posed to be hot, call your
local Service Force Centre.
Let the cooking zone cool
down
The highest heat setting
has the same power as the
automatic warm up func-
tion
1. Switching off the cook-
ing zone
2 . Set the cooking zone us-
ing the sensor field
Do not place any objects
on the control panel
Switch off the cooking
zone. Switch the cooking
zone on again