What To Do If - AEG KFA58SM User Manual

WHAT TO DO IF...

Problem
You cannot activate the appli-
ance or operate it.
A Sound operates and the ap-
pliance deactivates.
A sound operates when the ap-
pliance is deactivated.
The appliance deactivates.
The residual heat indicator does
not comes on.
The Automatic Heat Up func-
tion does not operate.
The sensor fields become hot.
comes on
and number comes on.
If you tried the above solutions and cannot repair the problem, speak to your dealer or the
Customer Care Department. Give the data from the rating plate, three-digit-letter code for
the glass ceramic (it is in the corner of the cooking surface) and an error message that
comes on.
If you operated the appliance incorrectly, the servicing by a customer service technician or
dealer will not be free of charge, even during the warranty period. The instructions about
the customer service and conditions of guarantee are in the guarantee booklet.
Possible cause and remedy
• Activate the appliance again and set the heat setting in 10
seconds.
• You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
• The Child Safety Device or the Lock or Stop+Go operates. See
the chapter Operating instructions.
• There is water or fat stains on the control panel. Clean the
control panel.
You put something on one or more sensor fields. Remove the ob-
ject from the sensor fields.
You put something on the
field.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone should be hot, speak to the service cen-
tre.
• There is still residual heat on the cooking zone. Let the cooking
zone become sufficiently cool.
• The highest heat setting is set. The highest heat setting has the
same power as the Automatic Heat Up function.
• You decreased the heat setting from
only increase the heat setting.
The cookware is too large or you out it too near to the controls.
Put large cookware on the rear cooking zones if it is necessary.
The Automatic Switch Off operates. Deactivate the appliance and
activate it again.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some
time. Disconnect the fuse from the electrical system of the house.
Connect again. If comes on again, speak to the service centre.
What to do if...
. Remove object from the sensor
. Start from
47
and