Table of Contents
Advertisement
Unpacking Instructions
For your convenience, check-off boxes are
provided next to each step. As each step is
completed, place a check mark in the box. This
will insure that all steps have been completed and
will be helpful in finding your place should you be
interrupted.
WARNING
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Company. Substitution of parts or
accessories not designated for use with this product
by Emerson Company could result in personal injury
or property damage.
1. Open styrofoam unit containing fan. Remove top
half of styrofoam unit. Remove parts and check to
see that you have received the following:
a. Fan motor and housing assembly
b. One motor cover
c. One ceiling cover
d. Five blade flanges
e. One hanger ball/downrod assembly
f. One hanger bracket
g. One uplight lead assembly
h. One loose parts bag containing:
1. One setscrew
2. One 5/32" hex wrench
3. Eleven 10-32 x 5/8" oval head screws
4. Two 1" threaded studs
5. Two 1-1/4" threaded studs
6. Four knurled knobs
7. Three wire connectors
8. Two screws, 8-32 x 3/8"
9. Two pull chain pendant and coupling
10. One hairpin clip
11. One clevis pin
12. Two lockwashers
13. Sixteen 10-32 x 3/8" pan head screws
14. Sixteen flat washers
NOTE: Place the parts from the loose parts bags
in small containers to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
NOTE: Fan blades are ordered separately and are
packaged in a separate carton.
CEILING
COVER
FOAM
PACKING
PROTECTIVE
PLASTIC BAG
FOAM
PACKING
Electrical Requirements
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored and
capable of withstanding a load of at least 50 pounds.
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
!
To reduce the risk of fire, electric shock, or personal injury,
mount fan to outlet box marked acceptable for fan support,
and use screws supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are not
acceptable for fan support and may need to be replaced.
Consult a qualified electrician if in doubt.
If your fan is to replace an existing ceiling light fixture,
turn electricity off at the main fuse box at this time and
remove the existing light fixture.
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the main
fuse box before wiring. All wiring must be in accordance
with National and Local codes and the ceiling fan must be
properly grounded as a precaution against possible
electrical shock.
!
To avoid fire or shock, follow all wiring instructions carefully.
Any electrical work not described in these instructions
should be done or approved by a licensed electrician.
3
UPLIGHT LEAD
BLADE
ASSEMBLY
FLANGES
LOOSE
PARTS BAG
HANGER
HANGER BALL/
BRACKET
DOWNROD
ASSEMBLY
MOTOR AND
HOUSING ASSEMBLY
MOTOR
COVER
CARTON
WARNING
WARNING
WARNING
Advertisement
Table of Contents
