Summary Of Installation - Bell EXPRESSVU 2700 Installation And Setup

Installation Guide

SUMMARY OF INSTALLATION

Following is a summary of the procedures to install and set up your Bell ExpressVu
system. We recommend that you perform the procedures in the order presented.
1. Unpack the satellite antenna, receiver, and parts (see page 1-6)
and the optional installation kit, if you purchased one (see page 1-3).
2. Review "What You Need to Know" (see page 1-6).
3. Connect the receiver to your TV set, and make sure the Smart Card is installed
(see page 1-8).
4. Determine the approximate location of the Bell ExpressVu satellite
(see page 1-18).
5. Find the best location on your property for the satellite antenna, with a clear line
of sight to the satellite (see pages 1-18 through 1-20).
6. Assemble the satellite antenna and attach it to a solid surface (see pages 1-21
through 1-34).
7. Ground the satellite antenna, and wire it to the Bell ExpressVu receiver
(see pages 1-36).
8. Aim the satellite antenna for the strongest possible signal (see pages 1-38
through 1-42).
9. Connect the receiver to an active telephone connection (see page 1-48). With the
receiver wired to the TV and the antenna properly installed, you will be able to see
the Bell ExpressVu Program Guide, which tells you about available programs,
channels, and services.
10.Order your programming by calling the Bell ExpressVu Customer Service Call Centre
at 1-888-SKY-DISH (see page 1-51).
11.Program the remote control to control the receiver and your other electronic
equipment. This feature is not available on all receiver models. (see page 1-52).
12.Wire the receiver to your audio system, VCR, DVD and other electronic equipment,
as required (see page 1-55).
Page 1-4