Program The Remote - Bell EXPRESSVU 2700 Installation And Setup

Installation Guide

PROGRAM THE REMOTE

For certain models of Bell ExpressVu receivers you can program the remote to control
not only the receiver, but your VCR, TV, and amplifiers. This remote supports most
brands and models; however, there may be some brands or models that it does not
support. You can program the remote to control a maximum of four different electronic
components. Which component is being controlled by the remote depends on the current
mode of the remote:
¥ The satellite receiver (controlled in SAT mode)
¥ The TV set (controlled in TV mode)
¥ A VCR (controlled in VCR mode)
¥ One auxiliary item, such as an amplifier, a cable TV box, or a second TV or VCR
(controlled in AUX mode).
Before beginning the following procedures, make sure that all electronic components are
powered ON. Make sure that there are fresh batteries installed in the remote.
The remote is already programmed to control the receiver. However, if any of the
following conditions apply, you will need to match the remoteÕs address to the receiverÕs
address:
¥ You have multiple receivers and remotes.
¥ Your receiver does not respond to remote commands (even with fresh batteries
installed in the remote).
¥ Your remote is damaged and replaced with a new unit.
For instructions on how to do this, as well as for full instructions for your remote
control, please refer to your User Manual.
Page 1-52