Safety Instructions - Bell EXPRESSVU 2700 Installation And Setup

Safety
Instructions
You should always follow these instructions to help ensure against
injury to yourself and damage to your equipment.
¥ Read all safety and operating instructions before you operate the receiver.
¥ Retain all safety and operating instructions for future reference.
¥ Heed all warnings on the receiver and in the safety and operating instructions.
¥ Follow all installation, operating, and use instructions.
¥ Unplug the receiver from the AC power outlet before cleaning. Use only a damp cloth
for cleaning the exterior of the receiver.
¥ Do not use accessories or attachments not recommended by the manufacturer, as they
may cause hazards and will void the warranty.
¥ Do not operate the receiver in high-humidity areas, or expose it to water or moisture.
¥ Do not place the receiver on an unstable cart, stand, tripod, bracket, or table. The
receiver may fall, causing serious personal injury and damage to the receiver.
¥ Do not block or cover slots and openings in the receiver. These are provided for
ventilation and protection from overheating. Never place the receiver near or over a
radiator or heat register. Do not place the receiver in an enclosure such as a cabinet
without proper ventilation.
¥ Do not stack the receiver on top of or below other electronic devices.
¥ Operate the receiver using only the type of power source indicated on the marking
label. Unplug the receiver power cord by gripping the power plug, not the cord.
¥ The receiver is equipped with a three-wire ground-type plug. This plug will fit only
into a ground-type power outlet. If you are unable to insert the plug into the outlet,
contact an electrician to replace the outlet. Do not defeat the safety purpose of the
ground-type plug.
¥ Route power supply cords so that they are not likely to be walked on or pinched by
items placed upon or against them. Pay particular attention to cords at plugs,
convenience receptacles, and the point where they exit from the unit.
¥ Do not overload wall outlets or extension cords, as this can result in a risk of fire or
electrical shock. Never insert objects of any kind into the receiver through openings,
as the objects may touch dangerous voltage points or short out parts. This could cause
fire or electrical shock.
Page i