Order Your Bell Expressvu Programming - Bell EXPRESSVU 2700 Installation And Setup

ORDER YOUR B
This procedure notifies the Bell ExpressVu Customer Service Call Centre that your
system is on-line and installed. You need to have your services activated before you can
start enjoying your desired programming. Prior to authorization, you will see the Bell
ExpressVu XPRS Preview Channel and perhaps an unscrambled program channel such as
CBC. You must authorize your services when you first install your Bell ExpressVu
system, and whenever you request to add or remove services.
All you need to do is call the Bell ExpressVu Customer Service Call Centre at 1-888-
SKY-DISH and notify them that your system has been installed and you would like to
begin receiving programming. The Service Representative will explain the available
program packages and ˆ la carte services and take you through the authorization
procedure and software download steps. When the services are authorized, you should
see channels other than the Bell ExpressVu Preview Channel.
You will need to give the Service Representative information about your system. To get
this information, do the following. Power the receiver OFF, using the remote control
Power button (not the receiver Power button). Ensure that the remote control is in SAT
mode, (applies only to certain models and receivers), then press the Info or System
Information button on the remote. This will display the Important System
Information menu, as shown below. To exit from this menu, press the Select button
on the remote.
Note: Even though there is information on the screen the receiver is still OFF. You will
have to press the Power button on either the remote or the receiver to turn the receiver
back ON.
SERVICE CENTRE PIN
As an option, the Service Representative will ask you if you want to establish a Bell
ExpressVu Customer Service Call Centre Personal Identification Number (PIN). See
ÒSecurity FeaturesÓ on page 1-53 for more information.

Order Your Bell ExpressVu Programming

E V
ELL XPRESS U
Installation and Setup
PROGRAMMING
Page 1-51