Security Features - Bell EXPRESSVU 2700 Installation And Setup

SECURITY FEATURES

There are two levels of security: receiver security and Bell ExpressVu Customer Service
Call Centre security. Each method works independently of the other. You can use either
method or both methods, or you can decide not to use the security features at all.
RECEIVER SECURITY
Receiver security locks control which channels or programs can be viewed, and
whether services such as Bell ExpressVu PPV events can be purchased using the
receiver. Locked programs or channels require the viewer to enter a password
for viewing them. For example, you can set programs with violence to be
security locked.
The ratings and extended ratings (content) code locks that are used for
security locks reflect the codes that were assigned to the programs by the
original program providers. These codes are provided for your assistance,
but you should be aware that the actual content of the programs may differ
from the assigned codes.
When you lock the system, you must enter and verify a password. Thereafter, this
password must be used to unlock the system. You can change this password at any time.
If you lock the system, and then forget your password, you will not be able
to watch locked programs using the receiver. You cannot reset the receiver
to default settings to discard a password that you have forgotten. You will
need to call the Bell ExpressVu Customer Service Call Centre at 1-888-
SKY-DISH to authorize them to override your receiver password. After this
is done, you will need to define a new password for the receiver if you want
to use the security locks.
Once you lock the system, the security locks that you have defined are activated. Also,
additional cost services (such as PPV programs) are automatically security locked when
you lock the system. This means you will have to enter your password to get PPV
programs.
If you attempt to access a locked item (such as a locked channel), you will be asked
to enter the password. You are allowed three attempts to enter the correct password.
If the correct password is not entered, the receiver will not allow more attempts for
several minutes.
If you enter the correct password, you can then see the locked item. If you exit the
locked item, you must reenter the password to see it again.
You can unlock the system so that you will not be prompted for the password again.
The system will be unlocked until you lock it again.
Installation and Setup
Security Features
Page 1-53