Connect Receiver To Telephone Connection - Bell EXPRESSVU 2700 Installation And Setup

Installation Guide

CONNECT RECEIVER TO TELEPHONE CONNECTION

Your Bell ExpressVu receiver(s) must be connected to a telephone line at all times.
To connect your receiver to a phone line, plug one end of the telephone cord provided
to the connection at the back of the receiver, and plug the other end into an active
telephone jack.
The telephone connection is required for several features, including some remote
diagnostics; the use of multiple receivers in the same household at no additional monthly
charge; and pay-per-view (PPV) purchases. In the case of multiple receivers in the same
household, all of the receivers must be connected to phone lines with the same telephone
number.
The receiver calls Bell ExpressVuÕs Customer Service Call Centre on a regular basis.
These calls use a toll-free number and will not appear on your telephone bill. The
receiver will never interrupt your own telephone calls. If you try to make a call while the
receiver is using the line, the receiver will immediately hang up and try its call later.
TELEPHONE CONNECTION DIAGNOSTIC TEST
This test checks that the receiver telephone connection is correct. Under Main Menu
then Diagnostics select the Phone Connection option to begin the test. The receiver
displays a message asking you to wait until the test is completed. If the telephone
connection is correct, the receiver displays a message that says ÒPhone Connection OK.Ó
If the telephone is not connected properly, the receiver displays a failure message. In this
case, see the Performing Diagnostic Tests section of the Problems and Solutions Tables in
your User Manual.
You must also set up the receiver for the type of telephone system you have (touchtone
or rotary/pulse), and specify a telephone number prefix, if such a prefix is required to
place an outside call.
Page 1-48