Table of Contents
Advertisement
24 www.electrolux.com
A
Change of the
type of gas
From natural
gas to liquid
gas
From liquid gas
to natural gas
3.
Attach the knob for the oven func-
tions.
4.
Light the oven burner. Refer to the
section "Gas oven cooking: Ignition of
the oven gas burner".
5.
Turn the knob for the oven functions
to the maximum position and let the
oven heat for 10 minutes.
6.
Turn the knob for the oven functions
from the maximum to the minimum
position.
Control the flame. If the flame goes out,
do the procedure from point 1 to point 6
again. There must be a small regular
flame on the oven burner crown.
The manufacturer declines liability if
you do not obey these safety meas-
ures.
13.9 Grill injector replacement
1.
Remove the grill burner after remov-
ing the fixing screw A.
Adjustment of
the adjust-
ment screw
Fully tighten the
adjustment
screw in.
Release the ad-
justment screw
approximately
3/4 of a turn.
2.
Replace the nozzle by means of a No
7 socket spanner.
3.
Refit all parts and test.
4.
Before fixing of the screws, ensure
that the grill burner is pushed correct-
ly to the back panel.
The grill temperature cannot be
adjusted. To get a lower tempera-
ture or slower cooking time, lower
the grill pan away from the flame.
13.10 Levelling
Use small feet on the bottom of appliance
to set same level of cooker top surface
with other surfaces
13.11 Electrical installation
The manufacturer is not responsi-
ble if you do not follow safety pre-
cautions from chapter "Safety in-
formation".
This appliance is supplied with a main
plug and a main cable.
A
Advertisement
Table of Contents
