Electrical Installation - Electrolux EKI6451AOX User Manual

34 www.electrolux.com
13.4 Anti-tilt protection
Make sure that the surface behind the
appliance is smooth.
1. Set the correct height and area for the
appliance before you attach the anti-
tilt protection.
2. Install the anti-tilt protection 77 mm
down from the top surface of the
CAUTION!
Install the anti-tilt protection
to prevent the appliance from
falling under incorrect loads.
The anti-tilt protection only
works when the appliance is
put in a correct area.
Your appliance has the
symbols shown on the
pictures (if applicable) to
remind you about the
installation of the anti-tilt
protection.
CAUTION!
Make sure you install the anti-
tilt protection at the correct
height.
appliance and 49 mm from the left
side of the appliance into the circular
hole on the bracket. See the
illustration. Screw it into the solid
material or use applicable
reinforcement (wall).
3. You can find the hole on the left side
at the back of the appliance. See the
illustration. Lift the front of the
appliance (1) and put it in the middle
of the space between the cupboards
(2). If the space between the bench
cupboards is larger than the width of
the appliance, you must adjust the
side measurement to centre the
appliance.

13.5 Electrical installation

WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
Applicable cable types: H07 RN-F, H05
RN-F, H05 RR-F, H05 VV-F, H05 V2V2-F
(T90), H05 BB-F.
49 mm
77 mm
2
1