Electrical Installation - Electrolux EKK6130AO User Manual

30 www.electrolux.com
WARNING!
Make sure the flame does not go
out when you quickly turn the
knob from the maximum position
to the minimum position.
12.7 Levelling
Use small feet on the bottom of appliance
to set the appliance top surface level with
other surfaces.
12.8 Anti-tilt protection
CAUTION!
You must install the anti-tilt pro-
tection. If you do not install it, the
appliance can tilt.
Your appliance has the symbol
shown on the picture (if applica-
ble) to remind you about the in-
stallation of the anti-tilt protection.
Make sure you install the anti-tilt
protection at the correct height.
1. Set the correct height and area for
the appliance before you attach the
anti-tilt protection.
2. Install the anti-tilt protection 77 mm
down from the top surface of the ap-
pliance and 49 mm from the side of
the appliance into the circular hole on
a bracket (see fig.). Screw it into the
solid material or use applicable rein-
forcement (wall).
3. You can find the hole on the left and
right side on the back of the appli-
ance.
The appliance is delivered with a
left-hand bracket. You can buy a
right-hand bracket at your local
dealer.
Lift the front of the appliance (1) and
put it in the middle of the space be-
tween the cupboards (2). If the space
between the bench cupboards is
larger than the width of the appliance,
you must adjust the side measure-
ment to centre the appliance.
Make sure that the surface behind the
appliance is smooth.

12.9 Electrical installation

The manufacturer is not responsi-
ble if you do not follow the safety
precautions from the chapter
"Safety information".
This appliance is supplied with a main
plug and a main cable.
49 mm
77 mm
2
1