Set-Up; Checking The Contents; Installing The Units; Connections - American Audio UCD-200 User Manual

S -U
ET P
C C
HECKING THE ONTENTS
Be sure your UCD-200 package was shipped with the following:
UCD-200 Dual CD/USB player unit
User Manual (this booklet)
UCD-200 Controller Head Unit
Dual Male to Male RCA cable
I U
NSTALLING THE
Place your unit on a flat surface or mount it in a secure rack mount case.
Be sure the player is mounted in a well-ventilated area where it will not be exposed to
direct sunlight, high temperatures, or high humidity.
Try to place the unit as far as possible from TVs and tuners, as the unit may cause
undesirable interference.
C
ONNECTIONS
Be sure main power is connected last to prevent any electrical damage.
AUDIO CONNECTIONS: Use the included RCA cable to connect the UCD-200 outputs to
the line inputs of a mixer. Never connect a CD player's output to a mixers "phono"
inputs.
CAUTION: Be sure to use the supplied control cables. Using a different type of cable may
result in unit damage. To avoid severe unit damage, be sure main power is off when
connecting the control cables.
CAUTION
To avoid severe damage to
the unit, be sure the power
is off when making
connections to the unit.
©American Audio®
NITS
CAUTION
The player will work normally
when the main unit is mounted
with the front panel within 15
degrees of the vertical plane If
the unit is tilted excessively,
disks may not be loaded or
unloaded properly.
www.americanaudio.eu UCD-200™ User Manual Page 14