RADAR SENSOR INFORMATION
RADAR SENSOR CHECK PROCEDURE
1. A
2. Wait until the S
3. Move inside the vehicle.
4.
RADAR SENSOR OFF MODE (If equipped)
THE RADAR SENSOR CAN BE DEACTIVATED. PERFORM THE FOLLOWING:
1. P
2. ARM
TOYOTA RS3200 P
the system.
RM
Press the LOCK button on the remote control or lock the doors
with the key.
(Remember, the system will not ARM if any door is open.)
M
TATUS
ONITOR'S
The LED will flash 30 seconds after the last door or hatch is closed.
When movement occurs inside the vehicle, an alarm will be triggered
immediately. If sensor detects 2nd movement within 60 seconds after
the 1st warn away alarm trigger, then a regular ALARM activates for 60
seconds.
Note: If you find that the system does not perform as expected, contact
your Toyota dealer for more information.
D
the system to stop the A
ISARM
Press the UNLOCK button on the remote control or use the key to
DISARM the system.
SENSOR OFF
USH THE
SWITCH ON THE INSTRUMENT PANEL BEFORE
ARMING BY KEY OR REMOTE CONTROL
Immobilizer LED starts blinking.
THE SYSTEM WITH THE REMOTE CONTROL OR KEY WHILE THE IMMO
LED
.
BILIZER
IS BLINKING
T
RADAR SENSOR
HE
WILL DEACTIVATE DURING ARMING
NOTE: I
F YOU DISARM THE SYSTEM AFTER YOU SET THE RADAR SENSOR
OFF,
YOU HAVE TO REPEAT THE ABOVE PROCEDURE WHEN YOU
ARM THE SYSTEM IF YOU WANT TO DEACTIVATE THE RADAR SEN
.
SOR AGAIN
THE SYSTEM WILL AUTOMATICALLY CANCEL THE
RADAR SENSOR OFF MODE WHEN DISARMED
SECURITY SYSTEM
LUS
LED starts flashing.
.
LARM
.
.
.
Page 11
-
-