Glass Breakage Sensor Information; Glass Breakage Sensor Check Procedure - Toyota RS3200 PLUS Owner's Manual

Page 12 TOYOTA RS3200 P

GLASS BREAKAGE SENSOR INFORMATION

The RS3200 P provides protection for your vehicle above and beyond entry point monitoring–it
LUS
"listens" for the noise made by tapping on, or breaking of glass. Using a microphone designed
specifically for this task, the G
helps to prevent "false alarms" from occurring.

GLASS BREAKAGE SENSOR CHECK PROCEDURE

When the RS3200 P
LUS
of the G B S
LASS REAKAGE
Security system
LUS
B S
LASS REAKAGE ENSOR
was installed in your vehicle, care was taken to adjust the sensitivity level
. You may observe how it works following the procedure listed below.
ENSOR
1. A the system.
RM
Press the lock button on the remote control or lock the doors with
the key.
(Remember, the system will not A
open.)
2. Wait until the S
TATUS
The LED will flash 30 seconds after the last door, the trunk or hatch
is closed.
3. With the tip of a key, tap the center of the driver's door window.
Tap the glass with light to moderate force.
WARNING: Do not hit the glass with excessive force, especially in
cold weather, or you may crack or break it.
A W A A
ARN WAY LARM
T , make sure you performed the procedure correctly and try
RIGGERED
again. If you find that the system did not perform as expected,
contact your Toyota dealer for more information.
4. D the system to stop the W
ISARM
Press the unlock button on the remote control or use the key to
D the system.
ISARM
is capable of ignoring other noises, which
if any door, the trunk or hatch is
RM
M ' LED starts flashing.
ONITOR S
should be T . If the A
RIGGERED
A A
ARN WAY
is not
LARM
.
LARM
OPERATION
ARMING THE RS3200
The system may be A
RMED
TURN TOWARD THE FRONT
OF THE VEHICLE
PUSH THE LOCK SWITCH WHILE
THE DOOR IS OPEN
PRESS AND RELEASE
THE LOCK BUTTON
�
LIGHTS FOR
30
SECONDS
( - )
PRE ARMING
THEN
FLASHES
(
SYSTEM IS
)
ARMED
* The system will not A
RM
∆ If your vehicle is equipped
w