All manuals and user guides at all-guides.com
RADAR SENSOR INFORMATION
RADAR SENSOR CHECK PROCEDURE
1. A
Press the LOCK button on the remote control or lock the doors
with the key.
(Remember, the system will not ARM if any door is open.)
2. Wait until the S
The LED will flash 30 seconds after the last door or hatch is closed.
3. Move inside the vehicle.
When movement occurs inside the vehicle, an alarm will be triggered
immediately. If sensor detects 2nd movement within 60 seconds after
the 1st warn away alarm trigger, then a regular ALARM activates for 60
seconds.
Note: If you find that the system does not perform as expected, contact
4.
D
Press the UNLOCK button on the remote control or use the key to
DISARM the system.
RADAR SENSOR OFF MODE (If equipped)
THE RADAR SENSOR CAN BE DEACTIVATED. PERFORM THE FOLLOWING:
1. P
ARMING BY KEY OR REMOTE CONTROL
Immobilizer LED starts blinking.
2. ARM
BILIZER
T
TOYOTA RS3200 P
LUS
the system.
RM
M
TATUS
ONITOR'S
your Toyota dealer for more information.
the system to stop the A
ISARM
SENSOR OFF
USH THE
SWITCH ON THE INSTRUMENT PANEL BEFORE
THE SYSTEM WITH THE REMOTE CONTROL OR KEY WHILE THE IMMO
LED
.
IS BLINKING
RADAR SENSOR
HE
WILL DEACTIVATE DURING ARMING
NOTE: I
F YOU DISARM THE SYSTEM AFTER YOU SET THE RADAR SENSOR
OFF,
YOU HAVE TO REPEAT THE ABOVE PROCEDURE WHEN YOU
ARM THE SYSTEM IF YOU WANT TO DEACTIVATE THE RADAR SEN
.
SOR AGAIN
THE SYSTEM WILL AUTOMATICALLY CANCEL THE
RADAR SENSOR OFF MODE WHEN DISARMED
SECURITY SYSTEM
LED starts flashing.
.
LARM
.
.
.
Page 11
-
-