Front Wheel - Yamaha TW200E Owner's Manual

Front wheel

To remove the front wheel
WARNING
G
It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motorcy-
cle so that there is no danger of
it falling over.
1. Disconnect the speedometer ca-
ble from the front wheel.
2. Loosen the axle nut.
1
2
1. Speedometer cable
2. Axle nut
3. Lift the front wheel off the ground
according to the procedure on
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU24360 page 6-33.
4. Remove the axle nut, pull the
EAU24580
wheel axle out, and then remove
the wheel.
EWA10820
CAUTION:
Do not apply the brake after the
wheel has been removed together
with the brake disc, otherwise the
brake pads will be forced shut.
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
2. Lift the wheel up between the fork
legs.
NOTE:
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
ECA11070
1. Retainer
2. Speedometer cable
EAU24981
6-34
1
3. Insert the wheel axle, and then in-
stall the axle nut.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
90 Nm (9.0 m·kgf, 65 ft·lbf)
6. Connect the speedometer cable.
2
2
3
4
5
6
7
8
9