Yamaha TW200E Owner's Manual page 54

1
1. Drive chain slack
4. If the drive chain slack is incorrect,
adjust it as follows.
To adjust the drive chain slack
1. Loosen the brake pedal free play
adjusting nut.
PERIODIC MAINTENANCE AND MINOR REPAIR
1
(b)
1. Brake pedal free play adjusting nut
2. Axle nut
3. Adjusting plate
2. Loosen the axle nut.
EAU22830
3. To tighten the drive chain, turn the
adjusting plate on each side of the
swingarm in direction (a). To loos-
en the drive chain, turn the adjust-
ing plate on each side of the
swingarm in direction (b), and then
push the rear wheel forward.
NOTE:
Make sure that both adjusting plates
are in the same position for proper
wheel alignment.
6-22
CAUTION:
Improper drive chain slack will over-
load the engine as well as other vital
(a)
parts of the motorcycle and can lead
to chain slippage or breakage. To
2
prevent this from occurring, keep
the drive chain slack within the
3
specified limits.
4. Tighten the axle nut to the speci-
Tightening torque:
5. Adjust the brake pedal free play.
After adjusting the brake pedal free
play, check the operation of the
brake light.
fied torque.
Axle nut:
90 Nm (9.0 m·kgf, 65 ft·lbf)
(See page 6-18.)
WARNING
ECA10570
2
3
4
5
6
7
EWA10660
8
9