Operation And Important Riding Points; Starting A Cold Engine - Yamaha TW125 Owner's Manual

2003
Hide thumbs Also See for TW125:
Table of Contents

Advertisement

OPERATION AND IMPORTANT RIDING POINTS

WARNING
G
Become
thoroughly
with all operating controls and
1
their functions before riding.
Consult a Yamaha dealer re-
2
garding any control or function
that you do not thoroughly un-
3
derstand.
G
Never start the engine or oper-
4
ate it in a closed area for any
length of time. Exhaust fumes
5
are poisonous, and inhaling
them can cause loss of con-
sciousness and death within a
6
short time. Always make sure
that there is adequate ventila-
7
tion.
G
Before starting out, make sure
8
that the sidestand is up. If the
sidestand is not raised com-
9
pletely, it could contact the
ground and distract the opera-
tor, resulting in a possible loss
of control.
EAU15950

Starting a cold engine

EWA10270
In order for the ignition circuit cut-off
familiar
system to enable starting, one of the
following conditions must be met:
G
The transmission is in the neutral
position.
G
The transmission is in gear with
the clutch lever pulled and the sid-
estand up.
WARNING
G
Before
starting
check the function of the igni-
tion circuit cut-off system ac-
cording
described on page 3-11.
G
Never ride with the sidestand
down.
1. Turn the fuel cock lever to "ON".
2. Turn the key to "ON" and make
sure that the engine stop switch is
set to "
".
3. Shift the transmission into the neu-
tral position.
EAU16060
NOTE:
When the transmission is in the neutral
position, the neutral indicator light
should be on, otherwise have a
Yamaha dealer check the electrical cir-
cuit.
EWA10290
the
engine,
NOTE:
If the engine fails to start, release the
start switch, wait a few seconds, and
to
the
procedure
then try again. Each starting attempt
should be as short as possible to pre-
serve the battery. Do not crank the en-
gine more than 10 seconds on any one
attempt.
For maximum engine life, never ac-
celerate hard when the engine is
5-1
4. Turn the starter (choke) on and
completely close the throttle. (See
page 3-8.)
5. Start the engine by pushing the
start switch.
6. After starting the engine, move the
starter (choke) back halfway.
CAUTION:
ECA11040

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents