Rear Wheel - Yamaha TW125 Owner's Manual

2. Lift the wheel up between the fork
legs.
NOTE:
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
1
1. Retainer
2. Speedometer cable
3. Insert the wheel axle, and then in-
stall the axle nut.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the axle nut to the speci-
PERIODIC MAINTENANCE AND MINOR REPAIR
fied torque.
Tightening torque:
Axle nut:
90 Nm (9.0 m·kgf, 65.1 ft·lbf)
6. Place the rubber cover at the bot-
tom of the right-side fork leg in the
original position.
7. Install the rubber cover at the bot-
tom of the left-side fork leg.
2
8. Connect the speedometer cable.

Rear wheel

To remove the rear wheel
1. Axle nut
2. Brake pedal free play adjusting nut
3. Brake rod
4. Brake camshaft lever
5. Drive chain slack adjusting plate
6-34
WARNING
G
It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motorcy-
cle so that there is no danger of
it falling over.
1. Loosen the axle nut.
2
3
5
(a)
1
2. Remove the brake pedal free play
EAU25080
EAU25420
EWA10820
2
3
4
5
4
6
7
8
9