Yamaha TW125 Owner's Manual page 67

PERIODIC MAINTENANCE AND MINOR REPAIR
adjusting nut, and then disconnect
the brake rod from the brake cam-
shaft lever.
3. Turn the drive chain adjusting
1
plate on each side of the swingarm
fully in direction (a).
2
4. Lift the rear wheel off the ground
according to the procedure on
3 page 6-32.
5. Remove the axle nut, and then pull
the wheel axle out.
4
6. Push the wheel forward, and then
remove the drive chain from the
5
rear sprocket.
NOTE:
6
The drive chain does not need to be
disassembled in order to remove and
7
install the wheel.
7. Remove the wheel.
8
To install the rear wheel
9 1. Insert the wheel axle from the
left-hand side.
NOTE:
Make sure that the drive chain adjust-
ing plates are installed with the
punched sides facing to the outside
and that the slot in the brake shoe plate
fits over the retainer on the swingarm.
1. Retainer
2. Install the drive chain onto the rear
sprocket, and then adjust the drive
chain slack. (See page 6-21.)
3. Install the axle nut, and then lower
the rear wheel so that it is on the
ground.
EAU25761
4. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
90 Nm (9.0 m·kgf, 65.1 ft·lbf)
6-35
5. Install the brake rod onto the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
6. Adjust the brake pedal free play.
(See page 6-18.)
WARNING
After adjusting the brake pedal free
play, check the operation of the
brake light.
1
EWA10660