Yamaha Fazer FZS600 Owner's Manual page 59

CAUTION:
@
G If coolant is not available, use
distilled water or soft tap water
instead. Do not use hard water
or salt water since it is harmful
to the engine.
G If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the engine may not be
sufficiently cooled and the cool-
ing system will not be protected
against frost and corrosion.
G If water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possible,
otherwise the effectiveness of
the coolant will be reduced.
@
19. Connect the fuel level sensor cou-
pler, connect the fuel hose to the
fuel tank and fuel cock, turn the
fuel cock lever to "ON", and then
place the fuel tank in the original
position.
PERIODIC MAINTENANCE AND MINOR REPAIR
EC000080
WARNING
@
G
Before installing the fuel tank,
make sure that the fuel hoses
are not damaged. If any fuel
hose is damaged, do not start
the engine but have a Yamaha
dealer replace the hose, other-
wise fuel may leak.
G
Make sure that the fuel hoses
are properly connected and
routed, and not pinched.
@
20. Start the engine, let it idle for sev-
eral minutes, turn it off, and then
slightly lift the fuel tank to check
the coolant level in the radiator. If
necessary, add coolant until it
reaches the top of the radiator.
21. Pour the recommended coolant
into the reservoir to the maximum
level mark.
6-16
EW000072 22. Install the radiator cap and reser-
voir cap, start the engine, and then
check the vehicle for coolant leak-
age. If coolant is leaking, have a
Yamaha dealer check the cooling
system.
23. Install the fuel tank bolts.
24. Pull the hoses down as shown.
25. Install the seat.
6