Remote Control Setup - Daewoo DT-4242N User Manual

Remote Control supporting the multi brand devices.
- The remote control provided is designed to operate the Daewoo PDP set.
- However, using the remote control, you can control the Cable Converter, VCR , DVD and Satellite Broadcasting
Receiver of other brands after setting up the remote control.
Notices:
- All the preset codes are erased when replacing the battery. In this case, you must set the remote control again.
- Some of the products may not be applied because of different signal system.
- This is only for the basic control of the devices.
HOW TO SET UP THE REMOTE CONTROL FOR USING OTHER DEVICES .
• Turn on the device. (Cable Converter, VCR , DVD or Satellite Broadcasting Receiver)
• Press the device selection button of remote control until it is flickering. It takes about 3 seconds.
• Press the assigned three digits code of the device using number key button of the remote control toward the IR
receiver of the device. The code number is provided below. Whenever pressing the number, the device
selection button will be flicked once.
• If the code is set properly, the device will turn off automatically. If not, repeat the process 3.
• As the device is turned off, press the flickering device selection button of the remote control once.
Then the lamp of the button will be turned off.
• Now, the setting-up of the device can be controlled by Daewoo PDP remote control.
VCR (STANDARD : 002)
Maker (Brand) Name
DAEWOO
JVC
MITSUBISHI
PANASONIC
PHILIPS
SAMSUNG
SHARP
SONY
DVD
DAEWOO
LG
PANASONIC
PHILIPS
SAMSUNG

Remote Control Setup

Remote Control Setup Code
Code Number (3 digit) List
002 008 060 062 063 067
068
003 006 009 043 044 046
084 089
111 114 124
046 052 075 122
016 070 087 088 106
005 040 042 045 048 049
053 064
078 081 090 108
041 055 056 059 061 065
066 091 095
048 049 057 074
047 050 051 076 080
152 160
150 168 169
157 170
155
151 163 164
SAT (STANDARD : 002)
Maker (Brand) Name Code Number (3 digit) List
DAEWOO 002
PHILIPS 018 031 032
SAMSUNG 079
15