Remote Control - Daewoo DP-42SP User Manual

Remote Control

* The number in (
the function of each button is explained in detail.
Input Select button
Used to select a desired input.
Every press of the button
cycles through the five
different modes: PC -->
Component 1(RGB H/V) -->
Component 1
ZOOM button
Used to zoom the screen. To enlarge,
press the (+) button, and to return to
the previous condition, press the (-)
button. (ZOOM Mode: Zoom 0~20)
Menu Select button
Select Menu by pressing
(Down), (Left), (Right) buttons.
Screen Select button
Every press of the button cycles through the four different
modes: Normal --> Dynamic --> Cinema --> User.
Sound Mode button
Every press of the button cycles through the five different
modes: Normal --> Movie --> Music --> News --> User.
Mute button
Mutes sound.
When Using Remote Control:
•
Be sure not to allow the Remote Control to drop or to become wet.
•
Keep it away from hot or moist locations.
) indicates the page in which
INPUT
SELECT
26
20
(Up),
19
29
Note
POWER
DISPLAY
ZOOM- ZOOM+
MENU
VOL VOL
PICTURE SCREEN
MODE FREEZE MODE
SOUND MUTE SLEEP
MODE
Installing the Batteries in your Remote Control:
•
To remove the cover, slide it outwards while pressing it down.
•
Place two batteries in the remote control by properly orienting
them, then close the cover.
• Use two "AAA" batteries.
• Be sure to use replacement batteries of the
same type as the original ones.
• The life of a battery depends on how much
it has been used.
Power button
Pressing the Power button of the Monitor
allows the Display to be in standby. (Red
light is shown in the Remote Control
Sensor.) At this time, if you press the
Power button of the Remote Control, the
Display is turned ON (Green light in the
Sensor).
Display button
Indicates the current state and resolution.
Menu button
30
Used to display a desired menu.
20
Volume button
Adjusts the volume.
22
Aspect Ratio
Adjusts the size of the screen
(Normal, 16:9, etc.)
28
Still
Used to view a still picture during
watching moving images. (Sound
can be heard.)
Sleep Timer 34
Each time you press this button, a different
input mode appears.
The sequence is as follows:
15 Min. --> 30 Min. --> 60 Min. --> 90 Min. --> 120 Min. --> OFF
After the time is selected, it automatically goes
standby when the selected time elapsed.
13