3. S
ETUP
Fuse Replacement
With a flat head screwdriver wedge the fuse
holder out of its housing. Remove the damaged
fuse from its holder and replace with exact
same type fuse. Insert the fuse holder back in
its place and reconnect power.
Mounting
Orientation
This fixture may be mounted on the included tripod stand, in any location, provided there is adequate
room for ventilation.
Rigging
There are two methods of mounting this fixture.
·
·
Adjust the angle of the each of the four lights on the fixture by loosening both knobs and tilting the
fixture. After finding the desired position, retighten both knobs.
Clamp hanging bolts
(2) two total
Light pan angle
adjustment knob
Light tilt angle
adjustment knob
4BAR™ User Manual
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
Using the included tripod stand
Using a clamp on the two clamp hanging bolts
When selecting installation location, take into consideration access and routine
o
maintenance.
Never mount in places where the fixture will be exposed to rain, high humidity,
o
extreme temperature changes or restricted ventilation.
The clamps for hanging are sold separately.
o
When using the clamp hanging bolts, BOTH of the two hanging positions MUST be
o
used.
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
7
2/8/2012 10:53 AM