Ac Power; Safety Instructions - Chauvet 4BAR User Manual

AC Power

This fixture has an auto-ranging power supply that can accommodate a wide range of input voltages.
The only thing necessary to do before powering on the unit is to make sure the line voltage you are
applying is within the range of accepted voltages. This fixture will accommodate between 100~240
VAC, 50-60 Hz. All fixtures must be powered directly off a switched circuit and cannot be run off a
rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for
a 0% to 100% switch.
All fixtures must be connected to circuits with a suitable Earth Ground.

Safety Instructions

·
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that
they also receive this instruction booklet.
·
Always make sure that you are connecting to the proper voltage, and that the line voltage you are
connecting to is not higher than that stated on the decal or rear panel of the fixture.
·
This product is intended for indoor use only! To prevent risk of fire or shock, do not expose fixture to
rain or moisture.
·
Make sure there are no flammable materials close to the unit while operating.
·
The unit must be installed in a location with adequate ventilation, at least 20 in (50 cm) from adjacent
surfaces. Be sure that no ventilation slots are blocked.
·
Always disconnect from power source before servicing or replacing lamp or fuse and be sure to
replace with same lamp source.
·
Secure fixture to fastening device using a safety chain.
·
Maximum ambient temperature (Ta) is 104° F (40° C). Do not operate fixture at temperatures higher
than this.
·
In the event of a serious operating problem, stop using the unit immediately. Never try to repair the
unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please
contact the nearest authorized technical assistance center.
·
Never connect the device to a dimmer pack.
·
Make sure the power cord is never crimped or damaged.
·
Never disconnect the power cord by pulling or tugging on the cord.
·
Avoid direct eye exposure to the light source while it is on.
There are no user serviceable parts inside the unit. Do not open the housing or attempt any
repairs yourself. In the unlikely event your unit may require service, please contact
CHAUVET® at: 954-929-1115.
4BAR™ User Manual
Please read these instructions carefully, which includes important
information about the installation, usage and maintenance of this
product.
4
2/8/2012 10:53 AM