Honda 08E51-S84-100 Installation Instructions Manual page 8

27. Route the LED harness installed in step 15 along the
combination switch harness and secure it with one
wire tie in the area shown. Reinstall the upper
steering column cover.
2-PIN
CONNECTORS
SECURITY SYSTEM
WIRE HARNESS
28. Locate the 2-pin connector included in the kit, and
firmly push the LED terminals into the connector
until they click into position, and lower the lock. Pull
gently on the wires to verify that they are locked into
the connector. Make sure that the terminals are
positioned properly.
29. Plug the 2-pin connector of the LED harness into the
2-pin connector of the security system wire harness.
8 of 9
UPPER STEERING
COLUMN COVER
WIRE TIE
LED
HARNESS
Insert
Lock
WHITE
WIRE
RED WIRE
AII 21018 (9909)
30. Connect the two fuse cases to each other, then
connect them to the 16-pin connector of the security
system wire harness. Attach the proper fuse label to
each connector.
16-PIN CONNECTOR
OF SECURITY SYSTEM
WIRE HARNESS
FUSE CASE OF
SECURITY SYSTEM
WIRE HARNESS
31. Attach the cushion tape to the fuse cases, then
secure the harness with one wire tie. Make sure the
cushion tape does not interfere with the fuse case
covers.
WIRE TIE
16-PIN
CONNECTOR
© 1999 American Honda Motor Co., Inc - All Rights Reserved.
FUSE
LABEL
FUSE CASES
CUSHION TAPE