Honda 08E51-S84-100 Installation Instructions Manual page 6

19. Remove the switch case.
• Using flat-tip screwdriver wrapped with a shop
towel, gently pry out the switch case.
• Mark the location of each connector.
• Unplug the three connectors from the switch
case, and pull out the switch case.
HOOKS
SHOP
TOWEL
FLAT-TIP
SCREWDRIVER
20. Unplug the 16-pin (blue) connector of the vehicle
harness plugged into the top of the fuse box, and
plug the 16-pin (blue) connector the security system
harness in between.
FUSE BOX
SECURITY SYSTEM
WIRE HARNESS
6 of 9
CONNECTORS
SWITCH CASE
VEHICLE HARNESS
16-PIN CONNECTOR
16-PIN
CONNECTOR
(Blue)
AII 21018 (9909)
21. In the upper corner of the fuse box, locate the 2-pin
and 3-pin connectors blue-taped to the vehicle
harness. Remove the tapes to free the connectors.
You may find the 3-pin connector near the terminals
blue-taped to the vehicle harness or behind the
vehicle harness.
BLUE TAPE
FUSE BOX
VEHICLE HARNESS
2-PIN CONNECTOR
BLUE TAPE
22. Plug the 2-pin and 3-pin connectors of the security
system wire harness into the 2-pin and 3-pin
connectors of the vehicle harness you just freed.
© 1999 American Honda Motor Co., Inc - All Rights Reserved.
VEHICLE HARNESS
3-PIN CONNECTOR
3-PIN
CONNECTOR
OF SECURITY
SYSTEM WIRE
HARNESS
2-PIN
CONNECTOR
OF SECURITY
SYSTEM WIRE
HARNESS