Operation - AT&T Call Display 435 User Manual

Operation

Call Waiting
Press Con the unit when you receive a call waiting signal.
Using this button puts your current call on "hold," connects you to the
new call, and displays the name/number of the call waiting call on the
bottom two lines.
Press Cagain to return to the first call. Use Cinstead of
using the switchhook or Flash button on your phone.
Message Waiting & NEW CALL Light
This light stays on when you have received call information but have not
yet reviewed it. If you subscribe to a voice mail service, this light flashes
if you have unretrieved messages waiting.
Call History
This product assigns each incoming call a number from 1 to 50. The
most recent call will have the highest number (for example, if 10 calls
have been received, call number 10 is the most recent, and call number
1 is the oldest). When the memory is full (50 calls), the oldest call
information is deleted to make room for new incoming call information.
Reviewing Call History
The screen displays the call information for about 30 seconds after it has
been received.
1 To review earlier calls, press -.
2 To advance through call history from an earlier call, press +. The
screen displays END OF LIST to indicate you have reviewed all the
calls in the call history. When you reach the end of the call history,
it begins again.
Removing Call Records from History
When the unit is idle, press r to erase a displayed call record. The
screen displays Call Removed. To remove all calls from call history, press
r when no call is displayed. The screen displays REMOVE All?.
Press r again.
NOTE: Once a call is removed from call history, it cannot be retrieved.
8