AT&T TL86109 User Manual page 15

Getting started
Telephone base installation
Option 2: If you have separate wall jacks for each line, install the telephone
base as shown below.
Plug the large end
of the AC power
adapter into a power
outlet not controlled
by a wall switch.
Raise the antenna.
Route the cords into
the slots.
Plug one end of the
black telephone line
cord into the
LINE 1/L1+L2
telephone jack at
the bottom of the
telephone base.
Plug one end of the
clear telephone line
cord into the
LINE 2 telephone jack
at the bottom of the
telephone base.
NOTE: This telephone provides minimal functionality during a power outage. When the
AC power is not available, many telephone features do not function. The telephone uses
power from the telephone line to enable you to make and answer calls using only the
corded handset and dial pad keys. However, only line 1 is available in the event of a
power failure.
Line 2 telephone
wall jack
Plug the small end of the AC power
adapter into the power jack at the
bottom of the telephone base and
route the cord through the slots.
Line 1 telephone
wall jack
9
Use a telephone line cord
(not included) to connect
the DSL filter and line 1/
line 2 telephone wall jack.
DSL filter (not included) is
required if you have DSL
high-speed Internet service.
Plug the other end of the
telephone line cord into the
DSL filter (if required).
Clear telephone line cord
Black telephone line cord
Plug the other end
of the coiled handset
cord into the jack at
the bottom of the
telephone base.