Oven Door And Glass Panels - AEG BE3002001 User Manual

24
Care and cleaning
Folding down the heating element
1. Remove the shelf rails.
2. Hold the heating element with the two
hands at the front
3. Pull it forwards against the spring pres-
sure and out along the support on both
sides.
4. The heating element folds down.
The oven ceiling is ready to clean.
Installing the heating element
1. Install the heating element in opposite
sequence.
Install the heating element correctly on the two sides above the support on the inner
wall of the appliance.
2. Install shelf rails.

Oven door and glass panels

To clean the oven door, remove it.
CAUTION!
Be careful when you remove the door from the appliance. The door is heavy!
Removing the oven door
1. Open the oven door as far as it goes.
2. Fully press clamping levers (A) on the
two door hinges.
3. Close the oven door until the first posi-
tion (angle approximately 70°).
4. Hold of the oven door with one hand on
each side and pull it away from the oven
at an up angle.
To install the door follow the procedure in re-
verse.
The number of glass panels if different for the different models.
CAUTION!
Put the oven door with the outer side down on a soft and level surface to prevent scratches.
Removing and cleaning the door glass panels
1. Remove the oven door.
A
A