Minimum Recommended Wire Sizes; Ground Fault Interrupting Outlets (Gfi's); Table 5, Minimum Recommended Wire Sizes - Trace Engineering DR Series Owner's Manual

Trace Engineering DR Series Owner's Manual - Version 3.2 - 9/7/98 - Page 25

Minimum Recommended Wire Sizes

MODEL
DR1512
DR2412
DR1524
DR2424
DR3624
NOTE: Consult NEC (National Electric Code) for actual wire sizes required for your specific
installation.
Important Precautions
The output side of the inverter's AC wiring should at no time be connected to public power or a
generator. This condition is far worse than a short circuit. If the unit survives this condition, it will shut
down until corrections are made.
Installation should ensure that the inverter's AC output is, at no time, connected to its AC input.
Review the installation diagrams included before you start making connections.

Ground Fault Interrupting Outlets (GFI's)

Trace Engineering has tested the following GFI's and found them to work satisfactorily with our
inverters:
LEVITON
PASS & SEYMOR
ACE Hardware
AC INPUT
120 VAC 220-240 VAC
10 gauge
6 gauge
10 gauge
6 gauge
6 gauge
Recommended

Table 5, Minimum Recommended Wire Sizes

6599
1591RI 4A957
ACE 33238 and 33236
120 VAC
14 gauge 12 gauge
10 gauge 10 gauge
14 gauge 12 gauge
10 gauge 10 gauge
Not
8 gauge
AC OUTPUT
220-240 VAC
16 gauge
14 gauge
16 gauge
14 gauge
Not
Recommended