Table of Contents
Advertisement
STEP 4: (SEE FIGURE 4)
•
Assemble a spacer, a washer, a wheel (air valve
facing out) and another washer onto the end of the
axle that has both the large and small holes.
•
Install a 1/8" x 1-1/2" cotter pin into the small hole in
the end of the axle.
•
Open the bail on the drive pin and install it through
the wheel and the large hole in the axle. Close the
bail to lock the pin in place.
1/8 x 1-1/2
COTTER PIN
WASHER
WASHER
FIGUre 4
STEP 5: (SEE FIGURE 5)
•
Insert the end of the flow control rod with only one
bend into the hole in the lever on the flow control tube
assembly.
FIGUre 5
WHEEL
DRIVE PIN
SPACER
FLOW
CONTROL
ROD
STEP 6: (SEE FIGURE 6)
•
Turn the spreader upright on its wheels.
•
Hook the double bent end of the flow control rod
through the hole in the slide gate bracket located near
the bottom of the hopper.
FIGUre 6
STEP 7: (SEE FIGURE 7)
•
Assemble the flow control mounting tube to the hitch
tube using two 5/16" x 1-3/4" hex bolts and 5/16"
nylock hex nuts. dO NOt tIGHteN Yet.
5/16 x 1-3/4
HEX BOLT
FIGUre 7
5
5/16 NYLOCK NUT
Advertisement
Table of Contents
