Minolta EP1030 User Manual page 71

Symptom
The copy has
dark specks or
spots.
The edge of the
copy is dirty.
The image on
the copy is not
aligned properly.
Rev. 1.x/22.05.02
6.1 When This Type of Copy is Produced
Possible Cause
The Original Glass is
dirty.
The Original Pad or
SDH pad is dirty.
The Original is very
thin or highly
transparent.
The information on
the back side of a
two-sided, thin
original may be
slightly reproduced on
the copy.
The Original Pad or
SDH Pad is dirty.
You have selected a
paper size larger than
the original.
The original is not
placed in the correct
position.
The original is not
placed in the correct
position.
The originals may not
be suitable for use in
the SDH.
63
Action
Wipe the Original Glass
clean with a soft dry cloth.
(See page 70.)
Wipe the Original Pad or
SDH pad clean with a soft
cloth dampened with mild
detergent. (See page 70.)
Place a blank sheet of
paper over the original.
(See page 18.)
Set the copier into the
Manual Exposure mode
and make the exposure
level lighter.
(See page 22.)
Wipe the Original Pad or
SDH pad clean with a soft
cloth dampened with mild
detergent. (See page 70.)
Select the same copy
paper size as the original.
Reposition the original, or
reload the paper in the
same direction as the
original.
Place the original correctly
on the Original Glass.
(See page 18.)
Or, load it onto the SDH
correctly along the Guide
Plates. (See page 18.)
Raise the SDH and place
the originals on the
Original Glass one at a
time. (See page 19.)
EP1030/1030F