Table of Contents
Advertisement
Hide ESSID: It is function in which transmits its ESSID to the air so that when wireless
client searches for a network, router can then be discovered and recognized. Default
setting is Disable.
o Enable: Select Enable if you do not want broadcast your ESSID. When select
Enable, no one will be able to locate the Access Point (AP) of your router.
o Disable: When Disable is selected, you can allow anybody with a wireless
client to be able to locate the Access Point (AP) of your router.
Regulation Domain: There are seven Regulation Domains for you to choose from,
including North America (N.America), Europe, France, etc. The Channel ID will be
different based on this setting.
Channel ID: Select the ID channel that you would like to use.
Tx Power Level: It is function that enhances the wireless transmitting signal strength.
User may adjust this power level from minimum 0 up to maximum 100.
Note: The Power Level maybe different in each access network user premises
environment and choose the most suitable level for your network.
AP MAC Address: It is a unique hardware address of the Access Point.
AP Firmware Version: The Access Point firmware version.
WPS service: Enable / disable
WPS State: Current WPS state in AP. It is be used for Microsoft Windows Connect
Now (WCN).
o Configured: This AP is be configured via WPS. It is not allow to be configured
WCN.
o Unconfigured: This AP is un-configured via WPS. It can be configured via
WCN.
61
Advertisement
Table of Contents
