Table of Contents
Advertisement
The detail instruction in Reset Button
Recovery procedures for non-working routers (e.g. after a failed firmware upgrade flash):
Hold the Reset Button on the back of the modem in. Keep this button held in and turn on the
modem. Once the lights on the modem have stopped flashing, release the Reset Button.
The modem's emergency-reflash web interface will then be accessible via
http://192.168.0.1
where you can upload a firmware image to restore the modem to a functional state. Please
note that the modem will only respond via its web interface at this address, and will not
respond to ping requests from your PC or to telnet connections.
Note:
Before powering on the router to enter the recovery process, please configure the IP
address of the PC as
192.168.0.100
and proceed with the following step by step guide.
1. Power the router off.
2. Hold the "Reset Button".
3. Power on the router. Then Router's IP will reset to Emergency IP address (Say
192.168.0.1)
4. Flash the firmware.
17
Advertisement
Table of Contents
