Table of Contents
Advertisement
Appendix D | DTMF Configuration codes
Panel Format
* 15 * 1 #
* 15 * 10 #
* 15 * 20 #
* 15 * 30 #
* 15 * 2 #
* 15 * 3 #
* 15 * 5 #
* 15 * 11
* 15 * 21 #
GPOP1
* 91 * 20
* 91 * 30
* 91 * 31
* 91 * 50
* 91 * 51
*98*t1*t2*t3*t4*t5*t6#
* 98 * xx #
GPOP2
* 92 * 10
* 92 * 11
Installation, Maintenance and Operation Manual V24a (June 2012)
Contact ID
High Speed (fast format)
SIA
Pin Only mode - Default
ContactID with Double Knock
4 + 1 express (DTMF mode only)
4 + 2 express (DTMF mode only)
High Speed with Double Knock
SIA with V21 tones
BSIA Form 175 Mode – Default
Standard Path Fail Mode Active Low (Failure of any communications path
causes a Low on GPOP1)
Standard Path Fail Mode Active High (Failure of any communications path
causes a High on GPOP1)
Standard Path Fail Mode 2 Active Low (Failure of both communications paths
causes a Low on GPOP1)
Standard Path Fail Mode 2 Active High (Failure of both communications paths
causes a High on GPOP1)
Where the following time delays apply to GPOP1 operation in mins 0-99
t1=IP fail delay, t2=IP restore delay, t3=GPRS fail delay, t4=GPRS restore
delay, t5=PSTN dial fail delay, t6=PSTN dial restore delay
(Up to S/W Version 52) Time delay before GPOP1 operates. xx=time in
minutes 1-99. default=15
Remotely (ARC) Controlled Active Low (0 from ARC sets output High, 1 from
ARC sets output Low) – Default
Remotely (ARC) Controlled Active High (1 from ARC sets output High, 0 from
ARC sets output Low)
Page 34 of 40
British Telecommunications plc 2012
Advertisement
Table of Contents
