Table of Contents
Advertisement
Make sure the pedal is in the heel down position
before turning it upside down.
This pre-existing mounting hole will be used when
fastening the mounting plate to the pedal housing.
MotorGuide Tour series foot pedal
1.
Remove power from the trolling motor and deploy the motor so it can turn
freely.
2.
Make sure the pedal is in the heel down position.
3.
Turn the foot pedal upside down.
4.
Remove the switch from the side of the foot pedal base.
5.
Place the angled edges of the mounting plate over the hinge pin on the
foot pedal.
6.
Align the attachment tab of the mounting plate with the existing mounting
hole on the bottom of the foot pedal base.
7.
Fasten the mounting plate to the underside of the base using the supplied
No. 6 (6/32) screw and nut.
8.
Reinstall the switch on the side of the foot pedal base.
9.
Turn the foot pedal right-side up.
SpotlightScan |
Removing the switch on the side of the foot pedal
base will make it easier to install the mounting plate.
Place the angled edges of the mounting plate over
the hinge pin on the foot pedal.
Installation Manual
Angled edges
on the hinge
pin
| 7
Advertisement
Table of Contents
