Lowrance SpotlightScan Installation Manual page 10

Mounting plate view with pedal
turned right-side up.
8 |
The plate will be installed on the
base before the sensor is attached.
These images show only how the
sensor fits on the plate.
10.
Make sure the mounting plate is clean and dry. Clean the plate with
rubbing alcohol, if necessary.
11.
Pull the lever arm back and align the position sensor on the mounting plate
using the attached adhesive strip.
•
Make sure the rib on the position sensor overlaps the widest angled
edge on the mounting plate.
12.
Connect the position sensor cable to your NMEA 2000 network.
SpotlightScan | Installation Manual
Rib
Rib
The rib must be flush
with the top edge of
the mounting plate.
Pull the lever arm back when
installing the position sensor on the
mounting plate.
butt against the
alignment tab.
The rib must