Lowrance SpotlightScan Installation Manual page 12

The end of the roller
plate should butt
against this rib
The roller plate should be flush with the rib on the
housing and the side of the cable mount. The textured
side of the plate should be in contact with the foam pads.
Lever arm
Roller plate
The sensor should be flush
with the side of the base
housing (top view).
10 |
5.
Make sure the mounting surface is clean and dry. Clean the surface with
rubbing alcohol, if necessary.
6.
Install the adhesive foam padding in the four cavities next to the cable
mount using the attached adhesive.
The side of
the roller plate
should butt
against the cable
mount
7.
Position the plastic roller plate so it butts against the rib in front of the
hinge pin and against the cable mount, as shown above. Make sure the
textured side of the plate bonds securely with the adhesive on the foam
padding.
Install the sensor so the rib grips the edge of
the base housing. Make sure the side of the
sensor is flush with the side of the housing.
8.
Pull the lever arm back and install the position sensor on the foot pedal
base using the attached adhesive.
9.
Reinstall the base plate.
10.
Connect the position sensor to your NMEA 2000 network.
SpotlightScan | Installation Manual
Front view of installed roller plate.
Lever arm
Roller plate
The rib on the sensor should
grip this edge on the base
housing (side view).