Table of Contents
Advertisement
Minn Kota foot pedal
The pedal should be in the heel down position.
1.
Remove power from the trolling motor and deploy the motor so it can turn
freely.
2.
Make sure the mounting surface is clean and dry. Clean the surface with
rubbing alcohol, if necessary.
3.
Pull the lever arm back and place the rib of the position sensor on the edge
of the base housing as shown below. Make sure the side of the rib butts
against the housing.
4.
Connect the position sensor cable to your NMEA 2000 network.
Move the lever arm back when installing the
SpotlightScan |
Installation Manual
position sensor.
The side of the sensor rib should
be flush against this part of the
base housing.
The rib should grip this edge of the
base housing.
| 11
Advertisement
Table of Contents
