Installation Procedure - Mitsubishi Electric Q Series Operation Manual

1.2 Installation Procedure

The following flowchart explains the procedure necessary for installing the Add-on Kit. It is assumed that
GP-PRO/PB III for Windows is already installed, and that the ladder program has been transferred to the PLC.
Add-on Kit Installation
Install the PLC Ladder Monitor Add-on Kit.
Project Creation / Startup
Create a new project file, or start an existing
project.
Registering Device Monitor feature
Register the Device Monitor feature in your
project.
Send project
Transfer the project to the GP unit.
Copy boot file to CF Card
Copy the PLC Ladder Monitor feature boot file
to the CF Card.
Insert CF Card
Insert the CF Card containing the PLC Ladder
Monitor feature into the GP unit's CF Card
socket.
Connect GP to PLC
Connect a data transfer cable to the GP and the
PLC
Start Ladder Monitor
Turn the GP and PLC units ON, and start the
Ladder Monitor feature.
Chapter 1 Overview and Setup
SEE 2.1.1 CD Installation (page 2-2)
2.1.2 Project File Creation/Running (page
SEE
2-2)
GP-PRO/PB III for Windows Operation
SEE
Manual (Included with the screen editor
software)
2.1.3 Device Monitor Registration (page 2-
SEE
2)
SEE
2.1.4 Project Transfer (page 2-4)
GP-PRO/PB III for Windows Operation
SEE
Manual (Included with the screen editor
software)
2.1.5 Copy Boot File to a CF Card (page 2-
SEE
4)
2.1.6 Insert the CF Card into the GP (page
SEE
2-4)
SEE 1.1.1 System Design (page 1-3)
SEE 2.1.7 Connect the GP to the PLC (page 2-4)
2.2 PLC Ladder Monitor Feature Startup
SEE
(page 2-5)
1-5