Setup; Ac Power; Fuse Replacement - Chauvet LED Followspot 75 User Manual

3. S
ETUP

AC Power

Fuse
Replacement
LED Followspot 75 User Manual (Rev. 07)
This product has a switchable power supply that can work with an input voltage range of
115 VAC or 230 VAC, 50/60 Hz.
To determine the power requirements for this product (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product's back panel, or
refer to the product's specifications chart. The listed current rating indicates the
product's average current draw under normal conditions.
Always connect this product to a protected circuit (circuit breaker or fuse),
making sure that it has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Follow the instructions below to change the fuse, if necessary.
Disconnect this product from the power outlet before replacing the fuse.
1) Wedge the tip of a flat head screwdriver into the slot of the fuse holder and pry out of
its housing.
2) Remove the blown fuse from its holder and replace with a fuse of the exact same
type and rating.
3) Insert the fuse holder back into place, and reconnect power.
Although the safety cap does have room for a spare fuse, this product ships with
no spare fuse.
Always replace a blown fuse of the same type and rating.
Page 7 of 17