Gxv3501/Gxv3504 Sip - Grandstream Networks GXV3501 User Manual

GXV3501/GXV3504 SIP Page
The GXV3501/GXV3504 has the ability to receive phone calls and make phone calls when an alarm
event is triggered through motion detection or alarm input. Register the GXV3501/GXV3504 to a
SIP server to enable the product to make and receive phone calls. To make phone calls out, the user
need to configure the Phone List properly.
Register GXV3501/GXV3504 to a SIP Server
1. From the GXV3501/GXV3504 home page, click Basic Settings > SIP.
2. Go to SIP Settings Tab.
3. Enter the required information.
Registered – The field shows the registration
status of the account with the SIP server. Click
Refresh to send out another registration.
Unregister on Reboot – The default setting is No.
If set to "Yes", the SIP user's registration
information will be cleared on reboot.
Account Name – The field configures the SIP
account name.
SIP Server – The SIP Server's IP address or
Domain name provided by your service provider.
Outbound Proxy – The IP address or Domain
name of the Outbound Proxy, Media Gateway, or
Session Border Controller. Used for firewall or
NAT penetration in different network
environments. If the system detects a symmetric
NAT, STUN will not work. ONLY outbound
proxies can provide a solution for a symmetric
NAT.
SIP User ID – User account information provided by your service provider (ITSP); this is either
an actual phone number or is formatted like one.
Authenticate ID – The SIP service subscriber's Authenticate ID used for authentication. It can
be identical to or different from the SIP User ID.
Authenticate Password – The SIP service subscriber's account password for the GXV to
register to the SIP server of the ITSP.
STUN Server – If the device is behind a router, a STUN server is needed to help penetrate the
NAT.
Registration Expiration – This parameter allows users to specify the time frequency (in
minutes) in which the GXV refreshes its registration with the specified registrar. The default
interval is 60 minutes.
Local SIP Port – This parameter defines the local SIP port used to listen and transmit. The
default value is 5060.
Firmware 1.0.1.18
Grandstream Networks, Inc. 08/2009
GXV3501/GXV3504 Digital Video Server
Page 17 of 31