Home Theater Master MX-500 User Manual page 26

1. Go to the programming mode by pressing the MAIN and ENTER
button simultaneously for three seconds.
2. Press the CLON button in programming mode.
3. Press either the SEND or RECV button depending upon the role
of the remote control. If the MX-500™ is to be copied from, press the
SEND button. If it is to be copied into, press the RECV button.
4. If you wish to clone the entire device, press the ALL button. If you
wish to clone only one device at a time, press the DEVICE button.
5. If you pressed the DEVICE button, it will show all the devices. Press
the device button you wish to clone.
6. Set the MX-500™ head to head with another MX-500™ to be cloned
from as shown below. The both units should be in either cloning from
or cloning to mode based on the selection in Step 3.
7. Press the START button for the both units to execute. It will take
about 40 seconds to complete the cloning and it will flash "GOOD"
upon completion of cloning. If it flashes "FAIL", repeat from Step 2.
8. Exit from cloning mode by pressing the MAIN button and then exit
from SET UP mode by pressing the MAIN button once again.
25