IC Realtime 1U Series User Manual page 119

Parameter
Remote Multiple
Host cast
group
PPPOE
Email
The email interface is shown as in
Please refer to the following sheet for detailed information.
Parameter
SMTP Server
Port
User Name
Password
Sender
Subject
Address
DDNS
Function
Set MULCAST address and port.
Enable MULCAST function.
Input the PPPoE user name and password you get from the
IPS (internet service provider) and enable PPPoE function.
Please save current setup and then reboot the device to
get the setup activated.
Device connects to the internet via PPPoE after reboot.
You can get the IP address in the WAN from the IP address
column.
Please note if you want to reboot the device please make
sure you have proper reboot right and there is no login user
in current device.
F igure 7-33 .
X 4 6 3 H 4 6 3 H 4 6 3 H X
Figure 7-33
Function
Input server address and then enable this function.
Default value is 25. You can modify it if necessary.
The sender email account user name.
The sender email account password.
Sender email address.
Input email subject here.
Input receiver email address here. Max input three addresses.
119