Fireplace Installation - Dimplex DF3003 Owner's Manual

Fireplace Installation

WARNING: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
WARNING: Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
WARNING: To reduce the risk
of fire, do not store or use gaso-
line or other flammable vapors or
liquids in the vicinity of the heater.
CAUTION:
circulation beneath the fire-
place insert is provided by two
rubber feet.
Do not install the fireplace
insert directly on carpet or
similar surfaces which may
restrict air circulation .
CAUTION:
Clearance for air
If installing the
fireplace in a carpeted area, place
a one-piece, solid, flat surface
under the fireplace. Ensure that
both of the feet rest securely on
this surface.
!
NOTE: The dimensions of the
fireplace insert are 30 ¼ in
(76.8 cm) wide X 25 ½ in (64.8
cm) high X 11 ½ in (29.2 cm)
deep (Figure 1).
does not require any additional
venting (Figure 1).
Mantel Installation
Install the fireplace into the
mantel (refer to mantel assembly
instructions).
!
IMPORTANT: If not using a
Dimplex mantel,
custom surround with an opening
of 30 ¾ in (78.1 cm) wide X 25 ¾
Figure 1
30 ¼"
(76.8 cm)
25 ½"
(64.8 cm)
Rubber
Feet
Air Circulation Areas
The fireplace
construct the
11 ½"
(29.2 cm)
7